Bussmann PDMKIT003 10 Circuit Minifuse & 5 Circuit Relay Block Kit
Bussmann 10 Circuit Minifuse & 5 Circuit Relay Block Kit
10 Circuit Minifuse & 5 Circuit Relay Block Kit
This block can be fitted with a combination of up to 10 minifuses or mini bladed breakers and 5 micro relays (SPDT). Typically each relay would be used to switch power supplied from a single minifuse circuit to an accessory eg. light. However, fuses & relays can be wired independently of each other to suit any design.
This block offers a high level of water and dust protection (rated IP66-IEC 60529) when assembled correctly with supplied cavity plugs and cover.
1 x 10 Fuse / 5 Relay block with silicone seal, dual busbar inputs & silicone stud caps.
1 x Tall cover.
2 x Stainless steel mounting brackets.
4 x Stainless steel lock washers.
4 x Stainless steel bolts.
10 x Silicone cavity plugs.
1 x Instruction sheet.
5 x 1.84mm² x 90mm long jumper cable (red) with terminal & silicone cable seal crimped to both ends.
20 x 1.84mm² x 300mm long output cable (red) with terminal & silicone cable seal crimped to one end.
10 x 1.84mm² x 300mm long output cable (blue) with terminal & silicone cable seal crimped to one end.
30 x #16-14 AWG (1.23 - 1.94mm²) Perma-Seal butt connectors with heat shrink insulation.
Power Source Connections:
There are 2 power input studs located on the back of the block. The left stud is used to provide a single power source for the 10 fuse/breaker circuits. The right stud can be used to provide a single power or ground feed to the 5 relays (coil pin 86). Please note that each input stud has a maximum input rating of 80A.
Power stud covers should be fitted after supply cables have been installed. The 2 x power supply cables & ring terminals are not included in this kit. It is recommended these cables be a minimum gauge of #10 AWG and fitted with external fuse protection. Prolec offer a variety of fuses & holders to provide external fuse protection.
Please disconnect the battery whilst installing this fuse block.
|Type of Store Credit value||Select|